BEA SA | LIEGE Science Park | ALLÉE DES NOISETIERS 5 - 4031 ANGLEUR [BELGIUM] | T +32 4 361 65 65 | F +32 4 361 28 58 | [email protected] | WWW.BEA-SENSORS.COM
1
1
2
3
4
5
1
2
3
1
1
1
1
2
2
1
©
BE
A
|
O
ri
gi
na
l i
ns
tr
uc
ti
on
s
|
4
2
.7
10
8 / V
2
-
0
7.
18
BEA hereby declares that the SPARROW is in conformity with the basic requirements and the other
relevant provisions of the standards 2014/53/EU and 2011/65/EU.
TROUBLESHOOTING
The door will not
open.
The LED is OFF.
The sensor power is off.
Check the wiring and the power supply.
The complete declaration of conformity is available on our website.
This product should be disposed of separately from unsorted municipal waste
The door will not
close.
The LED is OFF.
The door opens
and closes
constantly.
The sensor detects
objects outside its
detection field.
The LED
flashes quickly
after unlocking.
The sensor does
not respond to the
remote control.
Improper output
configuration on the sensor.
Improper wiring
The sensor is disturbed
by the door motion or
vibrations caused by the
door motion.
The sensor needs an access
code to unlock.
Batteries in the remote
control are weak or
installed improperly.
It rains and the
sensor detects for
no apparent reason.
The sensor detects the
motion of the rain drops.
Remote control badly
pointed.
Check the output configuration setting on each
sensor connected to the door operator.
Verify wiring
Make sure the sensor is fixed properly.
Make sure the detection mode is unidirectional.
Increase the tilt angle.
Reduce the field size.
Increase the immunity filter.
Increase the immunity filter.
Decrease the field size.
Enter an access code.
Cut and restore the power supply to access the
sensor. Change or delete the access code.
Check and change the batteries if necessary.
Point the remote control towards the sensor.
Make sure the detection mode is unidirectional.
Increase the immunity filter.
Install the ORA (rain accessory).
Metallic environment
ACCESS CODE
The access code (1 to 4 digits) is recommended to set sensors installed close to each other.
If you forget the access code,
cut and restore the power supply
.
During 1 minute, you can access the sensor without introducing any access code.
SAVING OR CHANGING AN ACCESS CODE:
DELETING AN ACCESS CODE:
