9
B
A
B
A
5
PZ1
6
«click»
«click»
TESTING AND ADJUSTING
Check the correct positioning of the
safety fields by placing an object in
the detection field.
After changing the angle, the sensor position or the environment, always launch a teach-in and test the correct
positioning of the detection fields.
Close the cover starting on the narrow
side (1). Do not hesitate to push.
To open the sensor again, position a screwdriver in the
notch and pull upwards until the cover comes loose.
FINAL STEPS
If necessary, adjust the tilt angle of the laser curtain by turning the
tilt angle adjustment screw (from 2° to 10°).
The service mode deactivates the safety detection during 15 minutes and can be
useful during an installation, a mechanical teach-in of the door or maintenance
work.
To enter the service mode, push on the button for at least 3 seconds.
When the sensor is in service mode, the LED is off.
To exit the service mode, push again for at least 3 seconds.
The service mode is deactivated automatically when launching a teach-in.
SERVICE MODE
> 3 sec.
