1
4
2
5
6
3
7
8
8
MOUNTING TEMPLA
TE
110
50
30
1
2
+4
0
-4
2/4
GREEN
OR
RED
Use the mounting template to cut
out the opening for the sensor.
Unclips the front face by inserting
a screwdriver as shown.
Push the push button shortly
to launch an automatic setup.
The LED will flash RED-GREEN.
When the LED turns OFF the
sensor is correctly installed.
Fasten the front face and test the
good functioning of the sensor.
If the LED continues flashing,
you have to adjust the sensor
further (see SETUP next page).
Connect the cable and insert
the sensor into the opening.
After inserting the sensor, fix
the 2 screws firmly.
The sensor can also be installed on the surface by using the surface
mount accessory (sold seperately).
Adapt the angle of the sensor.
INSTALLATION
OFF
RED-GREEN
NORMALLY OPEN
ACTIVE LOGIC
YELLOW-BLACK
NO POWER
NO DETECTION
DETECTION
NORMALLY CLOSED
PASSIVE LOGIC
YELLOW-WHITE
BROWN
Power supply
12-24V AC/DC
COM
NC
NO
Monitoring
GREEN
YELLOW
WHITE
RED
BLACK
BLUE
