Be-Tech 3001D-1GL, User Manual

Page: 9 / 27

SMART SAFE 3001D-1GL/3GL/5GL
SMART SAFE 3001D 1GL/3GL/5GL 8
USER INSTRUCTIONS
Now the smart safe is delivered to the user with the door open and ready to use.
ASSIGNING OWNER KEY

Make sure that the smart safe has been initialized.

Place an IB card against the receiver; an acoustic signal will confirm assignment of the card.

Only one owner key is allowed.
CHANGE AN OWNER KEY

Loose the screws of the back lock housing and remove the cover.

Press the Reset button of the PCB and follow the above procedure to assign a new owner key.
NOTICE
Once the owner key was deleted, the master key and the code will be deleted also.
ASSIGNING MASTER-KEY

Press */C button, the display will show LIGHT_ON .

Place the owner key against the receiver, the display will show P after one beep.

Place the owner key against the receiver again.

Place another IB card against receiver, the display will show P_S1 after one beep, master key will
be confirmed assignment. (Master key assignment can be continue before display off, the display
will show
P_S2
…
P_S5 till to FULL show on display)
DELETE SOME MASTER KEY

Press */C button, the display will show LIGHT_ON .

Place the owner key against the receiver, the display will show P after one beep.

Place the owner key against the receiver again.

Place a master key against the receiver, the display will show P_S1 after 2 beeps, the master key
will be deleted. (Master key can be deleted until the display off)
DELETE ALL MASTER KEY

Press */C button, the display will show LIGHT_ON .

Place the owner key against the receiver, the display will show P after one beep.

Place the owner key against the receiver two times again, the display will show P_ED , now all the
master key will be deleted.
CLOSING AND OPENING THE SAFE
To close the safe, the user must keep the door
pressed and key the code onto the keyboard,
followed by the key #. This code may consist
of anything between one and nine digits, at the
discretion of the user.
To indicate that the door has closed, a green
LED lights up in the receiver.
To open the safe, you just key in the same
code followed by the key #. As you set the
code, if you key in a wrong digit, you can press
* to delete it and write in the right digit.
You can change the secret code during any
safe closing or opening cycle.