Seite
19
von
26
2. INSTALLATION
Now fill up the water tank as follows:
1. First remove the mist outlet nozzles on the top of the water tank.
2. Now lift the water tank out of the base of the humidifier.
3. Turn it upside down and open it by pulling turn the water tank lid counterclockwise.
4. Then fill the water tank with water and be careful not to overfill it.
5. Close the water tank again by pushing the Tighten the fuel cap in clockwise
direction.
6. Now dry the outside of the water tank and set put him back in the base.
7. Put the steam outlet nozzles back into the for them provided opening and turn it to
any position.
IMPORTANT
Please note the following when filling the water tank:
•
Do not use any essential oils in the water tank (e.g .: eucalyptus or menthol) as these
could damage the device.
•
Do not put metals, chemicals, or detergents in the water tank. Never fill the water
tank completely full.
•
Never fill the water tank with water with a temperature above 40 ° C to avoid
deformation.
•
Only fill water into the water tank and never into the other parts of the humidifier.
•
Never fill the water through the steam outlet.
•
If the room temperature is less than 0 ° C, empty the water tank as freezing water
could damage the humidifier.
•
If there is a lot of water in the water tank, do not move the humidifier excessively,
otherwise water could leak and penetrate other parts of the humidifier and cause
irreparable damage.
•
Discoloration of the device is normal due to the evaporating water.
•
Use of aromatic oill:
1. You can use aromatic oil to give the escaping steam a pleasant scent.
2. First lift the water tank out of the base.
3. Then drip a little oil into the sponge provided and put the water tank
back into the base.
4. As soon as you switch on the device, the aroma diffuser function is
activated automatically.
5.You can wash the Schwann Aroma Oil and use it again as soon as it is
dry.
