Seite 12 von 14
Assembly of the fanhead
1. Remove the spinner lock nut and guard lock nut from the motor shaft.
2. Fit the rear guard, by the positioning on the location pins. Secure the guard to the motor
body with the guard lock nut.
3. Push the fan blade onto the motor shaft by matching the slots on the base of the blade
with the shaft pin. Secure the blade with the spinner lock nut. The spinner lock nut must
be tightened by turning it in a counter-clockwise direction. Check that the fan blade
rotates freely by turning with your hand.
4. Open the securing clip at the bottom of the front guard and loosen the clip screw. Position
the top clip on the uppermost part of the rear guard. Push the top clip down and press rim
of the front guard onto the rear guard. Close the bottom clip and tighten the screw.
STARTUP
1.
Place the fan on dry and level ground.
2.
Plug it into a standard 220-240V outlet.
Speed
Select the desired speed by pressing the respective button:
0
Off
1
Low speed
2
Medium speed
3
High speed
Oscillating function
To switch on the oscillating function, press the oscillation
button on the motor housing. If you wish to switch it off, pull
the button up.
