BDS MAB 855, Operating Instructions Manual, Page: 46 / 144

46
Preparation
MAB 855
ENGLISH
Safety instructions
WARNING
Risk of injury!
Do not use damaged, contaminated or worn tools. ►
Only perform tool changing when the machine is switched ►
off and not moving. Pull the plug out of the mains socket.
After inserting, check that the tool is engaged securely.
►
Only use tools, adapter and accessories that match the ►
machine.
Weldon industrial tool holder
Inserting the tool
Push the MK3/Weldon industrial holder (A or B) into the spin-
‹
dle taper (3) of the machine.
Before inserting, clean the Weldon shank of the tool and the
‹
tool holder.
Loosen both Allen screws in the tool holder (A, B) with the
‹
tool (I) supplied.
Insert the tool into the tool holder (A, B).
‹
NOTE
Insert the appropriate ejector pin (C-F) before inserting a ►
core drill.
Tighten both screws in the tool holder (A, B) with the tool (I)
‹
supplied.
Removing the tool
Loosen both screws in the tool mounting (A, B) using the tool
‹
(I) supplied and remove the tool by pulling it downwards.