4 | BDIUSA.COM
SOMA 6331
Place the
(C1) Top Panel
upside down on a soft,
flat surface. Place the
(C2) Lift Column
on the
(C1) Top Panel
and ensure it is in the correct
orientation. The triangle of threaded holes in the
bottom of the
(C2) Lift Column
should point
toward the front edge of the
(C1) Top Panel
(with the finger groove).
Attach the
(C2) Lift Column
to the
(C1) Top
Panel
using
4 (H1) M6 X 20 Screws
and tighten
with
(T1) Hex Wrench
.
The Lift Lever can be attached on either side or
the front edge of the
(C1) Top Panel
. Attach the
Lift Lever with
2 (H2) M4 X 16 Screws
. Tighten
with
Phillips Screwdriver
.
Do NOT remove tie
on Lift Lever.
PART/DESCRIPTION
QTY
T1-HEX WRENCH
1
H1-SCREW
4
H2-SCREW
2
NOT INCLUDED
Phillips Screwdriver
1
C1
STEP 1.
ATTACH LIFT COLUMN
ASSEMBLY
Ensure the triangle of
threaded holes
points
toward the finger groove
on the front edge of the
Top Panel
C2
H1
H1
H2
Do not remove plastic strap on lever until
assembly is complete.
CAUTION
Pressing the lever will release
and extend the column. This
should only be done once the
base is fully installed. Do not lean
or stand over the column during
assembly to avoid risk of injury.
Front
