BDI SEQUEL 6051, Owner'S Manual

Page: 13 / 14

bdiusa.com
customerservice@bdiusa.com
SEQUEL
6051/52
LIFT DESK
13
Technical Specifications
Height Range 24.75”–49.75” (63–126 cm)
Travel Speed 1.5" per second
Weight Capacity 150 lbs (68 kg)
Duty Cycle 10%, Max 2 minutes with 18 minutes off
Memory 4 position presets
Monitor Arm Compatible Yes
Setting the Upper and Lower Limits
The base is designed to go to its minimum and maximum heights, allowing for the widest possible range. If you
prefer to change the settings to a more narrow range, follow these steps:
To set the Lower-limit position:
Use the UP/DOWN buttons to move the base to the desired minimum height position. Press and release the
“ BDI ” button and the LED display should read “ S ”. Next, press and release the DOWN button. Now, press
and hold the “ BDI ” button (for about 2 seconds) until the LED display changes to “ 000 ” and then automatically
returns to show the selected height. The new lower limit is now set.
To set the Upper-limit position:
Use the UP/DOWN buttons to move the base to the desired maximum height position. Press and release the
“ BDI ” button and the LED display should read “ S ”. Next, press and release the UP button. Now, press and
hold the “ BDI ” button (for about 2 seconds) until the LED display changes to 999 and then automatically returns
to show the selected height. The new upper limit is now set.
Note:
•
You can set just the upper limit or just the lower limit or both.
•
After the upper and lower limits are set, the previous memory positions (1,2,3,4) may be outside the new
range of movement. If so, simply reset the momory positions.
•
If you attempt to revise a previously set upper or lower limit and it is outside of the existing range, you will
need to remove the previously set upper/lower limits first.
A Reset Procedure requires the desk to be fully lowered (beyond any lower limit set). Please ensure that you
have the proper clearance below the desk!
To remove the upper/lower limit positions:
Press and release the “ BDI ” button and the LED display should read “S”. Within 5 seconds, press and hold the
“ BDI ” button until the display flashes “555”. The upper and lower limits are now removed.