BDIUSA.COM | 13
NEED ASSISTANCE?
FINE TUNING
The hinges should not require adjusting. If the gap between the door and cabinet is uneven the
hinges can be adjusted. Remove the cover using a
slotted screwdriver (not included)
to access the
adjustment screws (see below).
Your door should come pre-adjusted to open completely level. If you need to adjust the door
opening angle, do so by inserting a
5mm Hex Wrench (not included)
into the hole above the cable
on the mechanism. Turn the wrench clockwise to lift the door up, turn the wrench counter-
clockwise to lower the door. Adjust the mechanism until the open door is level with the ground.
If you wish to adjust the push latch, twist the plunger while it's in the extended position. Turning it
clockwise will adjust the push latch in, and turning it counter-clockwise will adjust the push latch
out. This will adjust the closed position of the door.
HINGES
The back screw adjusts the door
forward or back.
The front screw adjusts the door
up or down.
PUSH LATCH
Clockwise = latch in
Counter-clockwise = latch out
DOOR OPENING
Clockwise = lift door up
Counter-clockwise = lower door
Summary of Contents for INTERVAL 7246
Page 2: ......
