Step 1
Place the Live In wire into the left hand
position of the connector, the switched
Live Out wire into the second from
left position of the connector and neutral
into right hand position of connector.
(see diagram 1).
Step 2
Set the timing as per timing table
(see diagram 3). The black square illustrates
where the dip switch should be situated.
For example:
10min 1 = OFF, 2 = ON, 3 = OFF, 4 = OFF
Step 3
To adjust lux level (i.e. the ambient light
level at which you would like your lights to
be activated via the PIR timer) please
refer to the lux level rotary adjuster
diagram. Rotate the lux level adjustment
clockwise to decrease the level of light
required to turn the lights on and
anticlockwise to increase the level of light
required to turn the lights on. See diagram
1 for position of lux level adjustment.
Step 4
Re-apply mains supply. The blue locator
ring will light up around the PIR button.
Your light or appliance, will now be
switched off. Please refer to operation
section.
Step 5
Reduce lux level to sufficient level by
rotating clockwise towards (–) if required.
(–) represents 0 lux level.
Installation Notes
N.B. After installation the PIR will require
approximately 5 minutes to initialise.
Operation of the Unit
1.
In standard operation, the PIR will
now sense body heat when passing
through the detection zone. Each time
the PIR is triggered the red LED will
light and reset the timer back to the start
of the timing period. The unit will then
wait 20 seconds approximately
before allowing the PIR unit to sense
and re-trigger the timing period again.
2.
If no one is present in the room or the
detection zone is not passed through,
during its set time period the timer
will time out, turning off the lights or
appliance and the blue indicator/locator
ring will light up.
3.
The PIR unit will only trigger the
lights or appliance if the ambient light
level is below that set on the lux level
adjustment.
4.
When the ambient light level is light
enough so the lights would not
normally come on with PIR use, the
override switch can be used turn on the
lights for the set period time. This can
be used in times where addional light is
required in a room.
To operate press the PIR lens, the red
indicator LED will light to show it has
been pressed and the timing will begin,
in the last minute of timing the red
LED will flash.
Continued overleaf...
3
INSTRUCTION GUIDE
|
ILLUMINATED PIR TIMER – 3 WIRE
2 mins 5 mins 10 mins 15 mins 20 mins 25 mins 30 mins 40 mins
50 mins 60 mins 70 mins 80 mins 90 mins 100 mins 110 mins 120 mins