06
07
Synchronizing Two Foundations
If simultaneous operation of two foundations is desired, use the sync cord to connect the electronics of both
foundations together.
Sync Cord
Wireless Remote
Head
Motor
Foot
Motor
Power
USB
LED
APP
Sync
Head
Motor
Foot
Motor
Power
USB
LED
APP
Sync
Attention: (1) If you want to toggle from "A" or "B" to "P" position (in the middle of "A" and "B") to realize sync control,
please press and hold "Flat" again until to a flat position. (2) The quadded cable is in master control when
synchronizing and the bluetooth must be pluged in the master control box. (3) The interval must more than
4s between plug in and plug out the sync cord.
STEP 1
：
Unplug foundations from the power source.
STEP 2
：
Connect the male ends of the sync cord to the female sync plugs of the control boxes (Refer to
illustration above).
STEP 3
：
Plug foundations back into the power source.
STEP 4
：
Press and hold and button, a beep sound of the buzzer will be heard and the backlit light
of the wireless remote flashes twice. Open the battery box and toggle the switch to “P” position (in the
middle of "A" and "B") first, next press and hold “FLAT” until you hear a beep sound of each buzzer
on the control box, which means the two foundations can be synchronized with one remote.
STEP 5
：
Open the battery box and toggle the switch to "A" or "B" position, you can control the two foundations
separately without removing the sync cord.
Remote Pairing
1.
Unplug the foundation from the power source then power it on,defaulting to remote pairing within 30s.
2. Next press and hold at the same time.
3.
You will hear a beep sound of the buzzer and the backlit light of the wireless remote flashes two times, which
means the pairing is successful.
The original remote that comes in the box is already paired to the foundation. No further action is required.In
the event that the remote is not paired with the foundation, follow the steps below.
Head
Motor
Foot
Motor
Power
USB
LED
APP
Sync
Quadded Cable
Triplex Cable
Foot lifting
Foot lowering
Head lifting
Head lowering
Zero Gravity
Remote Control Instructions
HEAD UP/DOWN BUTTONS
Press and hold to lift or lower the HEAD section.
FOOT UP/DOWN BUTTONS
Press and hold to lift or lower the FOOT section.
Press to adjust the foundation to the programmed reclined position for optimum weight distribution.
Press to adjust the foundation to the flat position.
Adjustment
Flat
