|
3
Reason
Low battery
Infrared signal could not reach the
blaster because the distance is too far or
angle is wrong
Obstacles blocking the infrared signal
Low battery
Overexposure to direct sunlight
Competing infrared transmission from
other devices, such as TV remotes
TROUBLESHOOTING
Problem
Blasters do not work
Blasters operate
automatically
Solution
Replace the batteries
Reduce the firing distance and firing angle
Remove the obstacles
Replace the batteries
Block sunlight or play in an area without
direct sunlight
Stop using or move away from competing
infrared devices
4 AA BATTERIES
PER GUN
PHILLIPS
SCREWDRIVER
NOTE
:
If normal operation of the product is disturbed or interrupted, strong electro-magnetic interference
may be causing a problem. Reset the product by turning it completely off and then back on. If normal
operation does not resume, try replacing the batteries and moving the product to another location.
Use a screwdriver to remove the
battery cover.
Insert 4 AA batteries. Make sure
the batteries are inserted with
the correct polarity.
Replace the battery cover.
BATTERY INSTALLATION
1
2
3
REQUIRED
WARNINGS REGARDING BATTERIES
-
+
-
+
•
Do not mix alkaline, standard (carbon zinc) and rechargeable (nickel hydride) batteries.
•
Do not mix old and new batteries.
•
Non-rechargeable batteries should not be charged.
•
Rechargeable batteries should be charged under adult supervision only.
•
Exhausted batteries should be removed.
•
The supply terminals should not be short-circuited.
•
Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
•
Do not hit batteries against hard objects.
•
Do not submerge batteries in water.
•
Batteries should be inserted with the correct polarity.
+
AA
-
3 YEARS
OLD AND UP
3+
UP TO 5 MIN.
ASSEMBLY
1 PERSON
ASSEMBLY