Pg. 9
HEATER/FIREPLACE OPERATION
CONTROL PANEL
•
This appliance has a safety-cut off that will engage if the fireplace overheats. The fireplace
will NOT automatically reset for safety reasons. To reset the appliance, unplug the unit for
15 minutes and then plug it back in.
•
This appliance can be controlled by the panel on the unit or the remote.
•
Do not press the buttons more than once in two seconds; it takes some time for the
fireplace to respond.
ON/OFF:
Turn the heating/display effect on and off.
DIMMER:
Controls the brightness levels. Press to cycle through dimness levels and the OFF setting.
HEAT 1/HEAT 2:
Controls the heating level. Press to cycle through the low setting (750W), high setting
(1500W), and the OFF setting.
STANDBY SWITCH:
Press to toggle standby on/off. This must be switched on to use the heater/fireplace.
It is located on the right side of the fireplace.
ON/OFF
DIMMER
HEAT 1
HEAT 2
•
Turn unit off and unplug before any maintenance. Wait at least 15 minutes after
unplugging before cleaning or maintenance.
•
Use a vacuum/duster to keep vent area and heater clear of debris and dust.
•
Fireplace exterior should be cleaned with a damp cloth or duster.
•
Do not use abrasive cleaners or liquids.
CARING FOR YOUR HEATER
