MOVING UNIT
•
Always use handles to move unit.
•
Drain water from tank before handing or moving.
•
Keep unit upright during transportation or storage. Do not move unit on its side.
•
Unit is heavy and 2 people are recommended during moving and installation.
CLEANING
•
Turn off and unplug appliance before cleaning or storage. Allow unit to cool completely.
•
It is very common for dust to gather in the inlet/outlet and cause overheating. Routinely clean the
housing and openings with a slightly damp cloth, vacuum cleaner, or dusting brush.
•
Do not clean with gasoline, benzine, thinner, or harsh cleaners.
•
Clean air filter as necessary:
-
Slide out the removable air filters.
-
Carefully clean air filter with mild detergent and lukewarm water.
-
Allow air filter to completely dry and reinsert.
STORAGE
•
Keep unit upright during transportation or storage. Do not move unit on its side.
•
For prolonged storage, do the following:
-
Tilt unit slightly backwards to drain all water from tank, then replace cap and stopper
-
Run fan mode for half a day to dry the interior
-
Remove batteries from remote
-
Turn off and unplug appliance. Wrap cord and plug into universal plug
-
Clean air filters and remove exhaust hose
-
Cover appliance
-
Store in a cool, dry place away from direct sunlight and dirt
TROUBLESHOOTING
REASON
Overheat feature activated
Remote has low battery
Not plugged in
Water full indicator on, water tank full
PROBLEM
Not working when
turned on
Does not turn on
SOLUTION
Allow unit to cool for 3 minutes
then try again
Replace remote batteries
Make sure unit plugged in properly
Drain water and restart unit
Room temperature lower than set
temperature (cooling mode)
Adjust temperature
Doors/windows open
Heat sources in room
Unit in direct sunlight
Exhaust hose not attached or blocked
Temperature set too high
Air inlet blocked
Dirty filters
Not cool enough
Close doors/windows
Remove heat sources
Block direct sunlight
Connect or clean exhaust hose
Adjust temperature
Clean air inlet
Clean filters
Too far from unit, remote not
aimed correctly
Remote not working
Bring remote closer and
point directly at unit
Low battery
Replace battery
Uneven ground
Excessive noise
Set unit on a flat, stable surface