GSC3219TN
Owner’s Manual
11
Step 9
a) Loosen the three pre-installed bolts
on the left side of body assembly and
allow 1/4 bolt’s length to extend from
the left side of body assembly.
b) Align the holes on the left side shelf
(A) with the bolts extended from the
left side of body assembly.
c) Push down the left side shelf until it
locks into place. Tighten all bolts
using the screwdriver provided.
d) Align the hole on the right side of the
left side shelf with the hole on the left
side of control panel .
e) Insert one bolt (BB) with one flat
washer (CC) and one spring washer
(DD) into each pre-drilled hole. (See
diagram to right)
f) Align the hole on the right side of the
left side shelf with the hole on the left
side of body assembly.
g) Insert one bolt (AA) with one flat
washer (CC) and one spring washer
(DD) into each pre-drilled hole
towards into the body assembly.
h) Repeat the procedure for the right
side shelf (S) and the right side of
body assembly .
i) Go back and tighten all bolts using
the screwdriver provided.
Step 10
a) Open the side burner lid and
place the side burner assembly
(R) on the right side shelf. Make
certain the venturi tube is
connected properly with valve.
b) Align the holes on the side
burner assembly with the holes
on the right side shelf.
c) Insert one bolt (EE) with one
spring washer (GG) and one flat
washer (FF) into each pre-drilled
hole. Tighten bolts by hand until
secure.
d) Go back to tighten all the bolts
using screwdriver provided.
AA
M6×30 bolt
2 PCS
BB
M6×15 bolt
2 PCS
CC
M6 flat washer
4 PCS
DD
M6 spring washer
4 PCS
EE
M4×15 bolt
4 PCS
GG
M4 spring washer
4 PCS
FF
M4 flat washer
4 PCS
