W W W . B B K P E R F O R M A N C E . C O M
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
STEP 1
Disconnect battery for 5 minutes. Reconnect or use a code reader to clear any
stored codes in the computer.
NOTE: IF THIS IS A NE
W
INSTALL, PROCEED TO STEP 2.
STEP 2
Turn ignition key to on position, do not start the engine.
STEP 3
Slowly depress the gas pedal to the floor, and then slowly release it. Do
this three (3) times. On the third press hold pedal to the floor until the check
engine light flashes release the pedal and turn the key off.
STEP 4
Now start engine. The gas pedal is now in synch with the larger throttle body.
GAS PEDAL/THROTTLE BODY IDLE RELEARN PROCESS
With the addition of the larger bore throttle body and its larger intake flap, the gas pedal and throttle body must be re-synched before starting the engine.
This must be done to prevent a check engine light for “increased idle”. The procedure is simple.
After installation instructions are complete, please follow the procedures below. If throttle body has already been installed, please just follow steps 1-4.
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
UPDATED LAST: February 2018