13
ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
• Assembly requires a 8/16” socket and ratchet( or
a 8/16” open-end wrench) and a Phillips Head
screw driver are needed to assemble trampoline/
enclosure. However, socket ,ratchet, open-end
wrench and screw driver are not provided.
• Assembly requires two or three persons. Keep
children away from the trampoline/enclosure until
it is fully assembled.
• Use gloves to protect your hands from pinch
points during assembly.
• The assembly steps refer to parts by their descrip-
tions and key numbers (see the PART LIST on
page 18). If a part is missing, see ORDERING
REPLACEMENT PARTS on page 18.
TRAMPOLINE/ENCLOSURE PLACEMENT
1. Place the trampoline/enclosure on a level surface
before use.
2. Adequate overhead clearance is essential. A
minimum of 7.3 m (24 ft.) from ground level is
recommended. Provide clearance for wires,
tree limbs, and other possible hazards.
Lateral clearance is also essential. Place the
trampoline away from walls, structures,
fences, and other play areas. Maintain a clear
space on all sides of the trampoline/enclosure.
3. Use the trampoline/enclosure in a well-lighted
area.Artificial illumination may be required for
indoor or shady areas.
4. Secure the trampoline/enclosure against
unauthorized and unsupervised use.
5. Remove any obstructions from beneath the
trampoline/enclosure.
6. The owner and supervisors of the trampoline
are responsible to make all users aware of
practices specified in this manual.
The trampoline/enclosure is only to be used as
an enclosure for a round trampoline.
7.
1. Make sure you understand the information in
the box at the top of this page before you
begin assembling the trampoline.
Lay four Top Tubes (1 and 2) on the ground as shown.
Make sure there is a T-Connector(3) on Top Tube (1)
and Socket(4) on the Top Tube(2).
Insert the small end of one Top Tube(2) into
T-Connector(3) .
Insert a Center(6) into the leg, slide a second leg (5)
onto the center. Tighten a Self-tapping Screw (10)
into the small hole in the leg (5). Insert Leg(5) into the
T-Connector(3).
Step on the Top Tube(1 and 2), lift the leg, and insert
the leg into the T-Connector(3)
You have now assembled one leg section.
Repeat this step to assemble three more leg
sections.
1
Center
1
3
4
6
5
10
10
2
2
2. Note: This step requires two persons. During
this step, you will connect the four leg sec-
tions.
Hold two leg sections in the positions shown.
Insert the small end of Top Tube (1) into the
T-Connector(3) on another Top Tube (2).
Repeat this step until all four leg sections are
connected.
5
2
3
4
1
2
2
2
2
2
2
2
2
1
1
1
3
3
3
3
3
3
4
4
4
4
4
1
1
3
5
5
5
5
5
5
5
1
1
1
6
6
6
4
4
3
14
14
Summary of Contents for BZ1409T
Page 2: ...2 ...
