TOYOTA
FJ CRUISER
2007 - REAR
SPEAKER
UPGRADE
Procedure
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
•
Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
•
Safety (eye protection, rechecking torque procedure, etc.).
•
Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
•
Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
.
Fig. 1A
Fig. 1B
1. Install
Speaker.
(a) Using NRT, remove blank panel. Fig 1A.
(b) Plug wiring harness into plug behind panel.
Fig 1B.
(c) Hold speaker in place, and hand tighten
silver screws as indicated to swing locks
out behind speaker assembly until tight
against sheet metal. Over tightening could
break assembly. Fig 1C.
Southeast Toyota Distributors LLC
Fig. 2A
Fig. 2B
Fig. 3A
Fig. 1C
2. Cut Speaker Cover
(a) Using supplied template and Dremel tool,
cut the panel as shown in figure 2A.
(b) Using supplied template drill (4) 3/32 holes
in panel as shown in figure 2B.
3. Install Grille into Speaker Cover
NOTE: Use side cutters to trim ribs on back of
cover. Fig 3A
(a) Using supplied push nuts, carefully secure
four mounting posts on Grille as shown in
figure 3A
(b) Reinstall Speaker Cover / Grille Assembly.
.
Page 2 of 5 pages
