SCION
tC
2005 -
VSE SUBWOOFER (BAZOOKA
®
)
Procedure
(e) Referencing Step 3. b, reassemble the rear
Cargo Floor panel & floor mat (if equipped).
Fig. 9-1
(f) Referencing Step 3. a, reassemble the rear
Tonneau Cover.
(g) Referencing Step 3. e, reassemble the rear
bench seat.
9. Install VSE Subwoofer
Fig. 9-2
(a) With the pigtail exiting the inner quarter
panels’ taillight access hole, connect the
pigtail to the VSE Subwoofer. (Fig.9-1)
(b) Align the lower mounting stud through the
enclosures’ lower hole, followed by the upper
mounting stud.
(1) Install the lower mounting assemblies’ flat
washer & locknut onto the lower mounting
stud, tighten using 10mm socket. (Fig.9-2)
Fig. 9-3
(c) Install the upper mounting assemblies’ flat
washer (with EVA gasket facing quarter
panel) & lock nut onto the upper mounting
stud, & SECURELY tighten using a 13mm
ratcheting box end wrench. (Fig.9-2)
Fig. 9-4
(d) Reinstall 10” driver into enclosure, by
connecting the 4 speaker connectors to the
driver (any sequence is acceptable). (Fig.9-3)
(1) Once connectors have been connected,
align the holes of the driver with the holes
of the enclosure, and fasten with the
supplied 8 Philips head screws. (Fig.9-4)
Fig. 9-5
(e) Adjust the Gain Control knob to the factory
suggested position (indicated by the setting
dot). (Fig.9-5)
(f) NOTE: Only reinstall front grille after
completing Step 13
“Test & Set Up
Procedures”
Page 9 of 17 pages
Issue: A 04/15/04
