MT6100BTA
MT6100BTAL
Installation Instructions
MT6100BTA & MT6100BTAL can be mounted to the
Power Rail PR3256 & PR3256K. Use the same mounting
procdure as mounting them to the tubbie stands.
(see page 1)
CAUTION: The Power Rail master power switch should
always be in the OFF position before adding
or exchanging accessories.
MT6100BTA & MT6100BTAL can be mounted to the
marine tubbie quick disconnect clamps MT-CL2-B,
MT-CL2-SS, and MT-CL3-SS. Use the same mounting
procdure as mounting them to the tubbie stands.
(see page 1)
Red +12v DC
Black -12v DC
Step 1. Decide which clamp is going to the used for the
amplified tubbie clamp and which will be the passive
tubbie clamp.
Step 2. Follow the clamp mounting directions that where
provided with the clamps.
Step 3. Run a positive 12v DC wire to the red wire and a neg-
ative 12v DC wire to the black wire on the amplifed
tubbie and passive tubbie mounting clamp PCB
pigtails.
Step 4. Run a jumper wire between the 2 white wires on the
amplifed tubbie and passive tubbie mounting clamp
PCB pigtails.
Step 5. Run a jumper wire between the 2 grey wires on the
amplifed tubbie and passive tubbie mounting clamp
PCB pigtails.
Step 6. Use the same mounting procdure as mounting tubbies
to the tubbie stands. (see page 1)
Amplified tubbie
mount
Passive tubbie
mount
To be able to use the MT6100BTA & MT6100BTAL with
the bar mount clamps you will have to wire clamps in
this configuration.
Power Rail Mount
(Not Included)
Roll Bar / Wake Tower Mount
(Not Included)
