Problem
Solution
Wireless occupancy sensor not working.
✔
Verify the X10 ID settings – see the
settings page on the thermostat applet.
✔
Verify the X10 ID settings of the sensor,
refer to the instructions provided with
the sensor.
✔
Check that the Wireless light on the
Control Module turns ON when the
sensor is activated.
✔
Try adjusting/moving the antenna wire.
Wired alert input not working.
✔
Verify the wired input settings – see the
Settings page on the thermostat applet.
Control module not connecting to Internet,
Uplink light does not come on.
✔
Verify that the green LED on the LAN
connector (on the side of the Control
Module) is illuminated.
✔
Verify that the amber LED on the LAN
connector is blinking.
✔
Verify that the Internet is up using a
computer.
✔
Try powering off all of your network
equipment (cable or DSL router, and all
local routers, switches, and power line
modules). Then power up your cable or
DSL router, followed by the rest of your
network equipment.
Heat or Cool does not turn off.
✔
The Heat or Cool outputs will stay on
for a minimum time period (default of 1
minute).
Emergency Operation
If you are unable to get your thermostat working and urgently need heating or cooling, you
can bypass the thermostat and manually turn your heat or cooling on. You will need to monitor
your temperature and manually turn it back off as well. This should only be considered as a
short term solution to be used until you can obtain service.
To set a manual bypass and turn
heat
on, connect the
red
and
white
wires together in the
thermostat cable that goes into your furnace/AC. Disconnect the wires to turn off.
To set a manual bypass and turn
cooling
on, connect the
red
and
yellow
wires together in
the thermostat cable that goes into your furnace/AC. Disconnect the wires to turn off.
24
Summary of Contents for BW-WT1
Page 1: ...Owner s Manual S N LABEL HERE Document BW WT4 1DOC...
Page 4: ......