Page
18
Assigned Outlets
Figure 6: Outlet Assignment
Universal Ethernet Controller Configuration:
Select a user number from the User Management Menu, the MRP unit will display the Assign Outlet
Menu:
-------------------------------------------
| User | Assigned Outlets |
| | C1,1| C1,2| C1,3| C1,4|
-------------------------------------------
1) engineer | N | N | N | N |
-------------------------------------------
1)...Add Outlet(s)
Add individual Outlets (X, X, X, X)
2)...Remove Outlet(s)
Remove individual Outlets
3)...Add All Outlets
Add all outlets to above user
4)...Remove All Outlets
Remove all Outlets from the above user
C)...Change Circuit Group Display next Circuit group of outlets
Enter Request:
NOTE:
If an outlet user’s list is changed while the user is logged in, their outlet list changes
dynamically. If enabled, an updated outlet status report will be issued.
“Y”
means the outlet is
assigned to the user.
“N”
means the outlet is NOT assigned to the user.
Change Outlet Name:
Allows the administrator to change the name of the outlets.
Enable/Disable Confirmation:
Enables/Disables the confirmation of choices. Example, “Turn off all
outlets [Y/N]?”
Enable/Disable Status Menu;
Enables/Disables whether outlet status menu is displayed.
Change Unit ID:
Allows the user to change the name of the unit. The defaulted is something similar
to MRP1. Allows the user to personalize or customize name or location, up to 31 alphanumeric
characters.
Change Alarm Threshold:
The Alarm Threshold is the value set that sounds the amperage alarm
when it reaches or exceeds the amperage value indicated.
Change Circuit Group:
Allows user to flip the display for units with cords going out the top of
cabinets.
Access Menu:
The Access Menu screen, allows for Outlet Operations, Network Configuration, or
Disconnection. To access the Network Configuration Screen,
type five Attention Characters
.
NOTE:
For initial network access, the IP address, subnet mask, and gateway must be
configured from the serial port.
Default setting is 0.0.0.0.
