4
Assembly Instructions
1.
Remove the plastic caps from the hanger bolts of the front legs (C) for the following steps.
2.
Attach two front legs (C) to the
front corner blocks of
the seat frame (B) by inserting the hanger bolts
through the drilled holes on the corner blocks and fit the flat washer (EE), lock washer (DD) and hex nut
(CC) onto each hanger bolt. Securely tighten the nuts with the provided open wrench.
NOTE
: DO NOT fully tighten all the nuts until the chair has been adjusted and all the legs are levelled so
that they do not wobble. Once adjusted then go back and tighten while making sure that the unit remains level.
3.
Lay one backrest (A) on a smooth and protective surface with the threaded inserts facing up.
4.
Attach the assembled seat frame (B) to the middle rail of the backrest (A). Insert four bolts (AA) with lock
washers (DD) and flat washers (EE) through the drilled holes on the seat frame (B) at rear corner blocks and
loosely tighten into the threaded inserts on the backrest (A).
5.
S
ecure the seat frame (B) to the backrest (A) by inserting two bolts (BB) with the washers (DD and EE)
through the drilled holes on the rear rail of the seat frame.
6.
Stand the assembled chair upright on a flat surface. Press down the seat cushion (B) to even all legs. Now,
tightly fasten all bolts and nuts with the provided hex wrench and open wrench.
7.
Repeat the same procedure to assemble the other chair.
