![background image](http://html1.mh-extra.com/html/bayrol/naturally-salt-salt-relax-power/naturally-salt-salt-relax-power_operating-and-installation-manual_2713062034.webp)
7 WIFI option
34
7
WIFI option
The Salt Relax POWER can be accessed remotely by using the WIFI option. A WIFI network that is connected to the Internet is required in order to
use this option. Remote access is set up via the web portal www.naturally-salt-poolaccess.com.
7.1
Scope of delivery, WIFI option
1
WIFI Modul with connecting cable
2
Cable grommet
7.2
Installing the WIFI module
Disconnect the Salt Relax POWER from the mains and remove the cover (see removing the housing front cover).
Create a feed-through for the cable on the front right of the cover (when viewed from the front) (see installing a cable grommet).
Open the two cover screws on the rear of the WIFI module (Picture 1).
Carefully loosen the cable ties (Picture 2).
Open the 4 screws of the cable glands (Picture 3).
Feed the cable end with the 4 individual wires through the cable grommet so that the connector is positioned on the inside of the cover
(Picture 4).
Position the connector at the designated location (WIFI) and attach the cover to the unit again. Make sure that the length of cable inside the
device is not too long but is also not under tension.
Carefully feed the cable through the cable opening of the module and connect the individual cables as described to the screw terminals
provided. Make absolutely sure that the cables are properly connected and seated securely.
(From left to right - GND: black, CB: green. CA: yellow, +12V: red)
Insert the cable length into the housing as shown and secure the cable on the inside as shown using the cable ties.
Carefully close the housing of the WIFI module.
Picture 1
Picture 2
Picture 3
Picture 4
7.3
Positioning the WIFI module
Look for a dry, dust-proof location to install the WIFI module. Make absolutely certain that the selected location offers good reception quality.
Carry out any necessary remote access settings as described under Network before positioning the WIFI module. If a good quality connection cannot
be established between the WIFI module and the wireless network, try using commercially available WIFI repeaters to see if that makes any
improvement.
Once you have found an appropriate installation location, secure the WIFI module to the wall.
You can make the settings on the Salt Relax POWER under the Network menu item as soon as the WIFI module has been installed.
Terminal
Colour
GND
Black
CB
Green
CA
Yellow
+12V
Red