4
Operating Instructions
You may occasionally notice small dark particles which are bits of carbon from the filter.
These carbon particles are safe and won't impede the operation of your Chillswell.
1. Prepare Filter
•
Remove Filter Cartridge from plastic cover
•
Do not to lose the Filter Cartridge 0-Ring
•
Soak Filter Cartridge in water for 20 minutes
•
Shake filter while under water to remove dark carbon particles and any trapped air
2. Wipe Down Water Chamber
•
Before connecting unit to the mains, wash the chamber parts using warm water
3. Assembly
•
Ensure Drain Plug underneath unit is secure on the unit
•
Place Unfiltered Water Chamber on to the Filtered Water Chamber
•
Place Filter Cartridge into the Unfiltered Water Chamber. Ensure Filter Cartridge is
secure
•
Place top on top of water chamber
•
Turn the switch to "ON" at the back of the unit
•
Empty water into the Unfiltered Water Chamber; allow water to run through to the
Filtered Water Chamber
•
Once the Filtered Water Chamber is filled, push and hold the tap down until water
comes out of the tap
4. Switching On
•
Once the unit is set up and connected to the mains the light will turn red when the unit
is in cooling mode
•
When cooling is complete the light will turn blue.
If the water cooler has not been used for some time, unplug the unit, drain all the water
and clean with warm soapy water.
Flush the water cooler and empty all water out through the tap.
