Tip: Always treat clean seed! This can also affect the seed
flow rate.
oPERATIoN
Treat mode
Step 1:
When ready to begin treating seed, ensure a collection bin
or bagging device is affixed to the Seed Discharge.
Step 2:
Fill the inlet hopper with seed (up to 100kg).
Step 3:
Pull the E-Stop button OUT to turn on power to the Control
Panel.
Step 4:
Turn the Bowl switch to ON. The Bowl speed may be
increased using the Bowl Motor touch pad arrows, located above
the Bowl Motor switch. The Bowl speed is pre-set from the factory
at 54. Hz and may be increased to a maximum 100 Hz.
Step 5:
Turn on the Blower Motor, Atomizer Motor and Liquid Pump
#1 (and #2 switches if both are used).
Step 6:
Push the Green Cycle Start Button. This will open the
Automated Slide Gate located directly under the Inlet Hopper and
dump the seed into the Mixing Bowl. The run cycle will treat seed
according to the set program and discharge when complete.
Warning! Wear proper personal protective equipment when
bagging treated seed: long sleeves, chemical resistant
gloves and a face respirator.
5
4
3
5
5
5
6
14
oPERATIoN
Summary of Contents for SeedGrowth 80996381
Page 1: ...CBT BASIC TURNKEY 80996381...
