Manual breast pump
EN
5
Assembling and disassembling the breast pump
■
Before you start assembling the breast pump, clean and sterilise the individual parts according to the
instructions contained in the chapter "Cleaning and sterilisation" and thoroughly wash your hands .
■
Always assemble the breast pump according to the following instructions . Otherwise the suction intensity
may decline .
■
Check that no part of the breast pump is damaged or worn out and that all parts that will be used during the
assembly are dry . Damaged or worn out parts must be replaced with new ones . To order replacement parts,
please contact an authorised service centre .
■
Slide the piston A
0
into the hole in the silicone diaphragm A
9
and push it until the piston A
0
passes
through the hole in the silicone diaphragm A
9
down to its bottom edge .
■
Insert the silicone diaphragm A
9
into the breast pump body A
3
and push it in until the silicone diaphragm
A
9
properly fits into the breast pump body A
3
and its edges are located over the rim of the breast pump
body A
3
.
■
Place the groove of the handle A
qa
under the piston A
0
and gently push it in until you hear it click in . The
objective is for the handle A
qa
to fit into the tab on the breast pump body and for it to be properly fastened
on the breast pump body A
3
.
■
For gentle stimulation expression, place the handle A
qa
in the first position on the piston A
0
. For strong
expression, which emulates the deeper and slower sucking action of the baby, place the handle A
qa
on to
the second position on the piston A
0
. Figure B
1
and
2
.
B
1
First stimulation phase with gentle expression
2
Second expression phase with strong expression
■
Place the cylinder cover A
8
on to the breast pump body A
3
with the handle A
qa
positioned according to
the procedure above, so that the handle A
qa
fits into the hole in the cylinder cover A
8
and gently push it in
so that the cylinder cover A
8
snaps on to the breast pump body A
3
and correctly holds the handle A
qa
.
■
Insert the silicone breast pad A
2
into the brace on the breast pump body A
3
and check that it fits tightly
in the brace on the body of the breast pump A
3
.
■
Attach the flap A
qs
by pushing its wider part into the bottom part of the breast pump body A
3
so that the
narrower part of the flap points outwards from the breast pump body A
3
.
■
Screw a bottle A
qd
on to the underside of the breast pump body A
3
. Place the bottle into the bottle stand
A
qg
.
■
To disassemble the breast pump proceed in the reverse sequence .
Assembling and disassembling feeding bottles
■
The instruction below describe how to assemble a feeding bottle and how to close it if you wish to store
breast milk in it .
