Bay Tek Games Chameleon Paradize, Service Manual

Page: 16 / 39

PROBABLE CAUSE REMEDY PROBLEM
Tongue
not
operating
correctly
Mechanical Problem
1. Assembly binding.
1. Loosen the screw on the tongue
slide. It is locate on the opposite side
of the clean window below the
assembly.
2. Check set screw on linkage
arm.
2. Tighten set screw
Calibration sensor problem
1. Calibration sensor not
reading silver tape strip.
1. Inspect and clean both pieces of
the silver tape. One in on the forked
end and the other is on the body.
2. Faulty wiring.
2. Check the wiring continuity from
the chameleon to the main board.
3. Faulty sensor.
3. Replace sensor if needed -
AABD5010
Player push
button
problem
Put the game
into test
mode.
Turn ON dips
6, 7, and 8
on Bank 2.
Push button.
CC is displayed.
1. Button is good
2. Check wiring from the motor to
the main board.
3. Replace main board.
CC is not displayed.
1. Button is bad.
2. Ensure switch is wired correctly.
Compare to working game.
3. Replace switch - A5PB7300
4. Check wiring from main board to
switch.
5. Replace main board
1. Dip switch setting on the
main board.
2. Diode board faulty.
3. Motor faulty.
Bug wheel spinning too fast
1. Turn dip 4 on bank 2 OFF
2. Replace as needed - AABD1204
3. Replace motor as needed -
A5MO1201
1. Replace motor - A5MO1201
Motor
problem
Check for
12v DC at
the motor
12v DC at the motor
No 12v DC at the motor
1. Check wiring from the main
board to the motor
2. Faulty main board.
Owners Manual Chameleon Paradize Page 16