Bay Networks Remote Annex 2000, Hardware Installation Manual, Page: 99 / 136

4-7 Remote Annex 2000 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Test Mode Diagnostics
Test Mode
Pressing the button within 3 seconds of either cycling on
power or resetting the unit via the button puts the Remote
Annex 2000 into test mode.
Test Mode Error-free Sequences
Table 4-3 summarizes the LED sequences that display in test mode
during an error-free start-up. A description of each sequence
follows
Table 4-3 .
Table 4-3. Test Mode Error-free LED States
Key:
●
On continuously.
✕
Off.
■
Flashing irregularly.
◆
Flashing regularly (about 1Hz).
Test
Test
Activity Power
green Unit
green Net
green Attn
amber Load
green Active
green
T1: Testing LEDs
● ● ● ● ● ●
T2: Testing
hardware
● ■ ✕ ✕ ✕ ■
T3: Testing
network
● ● ■ ✕ ✕ ■
T4: At monitor
prompt
● ● ● ● ✕ ■
T5: Looking for
boot file
● ● ● ● ◆ ■
T6: Loading code
using the boot
command
● ● ● ✕ ● ■
T7: Running
operational code
● ● ● ✕ ✕ ■