Bay Networks Remote Annex 2000, Hardware Installation Manual, Page: 97 / 136

4-5 Remote Annex 2000 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Normal Mode Error Sequences
Table 4-2 shows the state of the LEDs when an error occurs at given
stages of the start-up process. For example, if the Remote Annex 2000
fails during the testing hardware state (N2), the error condition is
hardware failure NE2. A description of possible causes and solutions
for each error condition follows
Table 4-2 .
Table 4-2. Normal Mode Error LED States
Key:
●
On continuously.
✕
Off.
■
Flashing irregularly.
◆
Flashing regularly (about 1Hz).
Activity NE2:
Hardware Failure The ROM diagnostics detected an Remote Annex 2000 hardware
problem requiring service. Call technical support.
Activity Power
green Unit
green Net
green Attn
amber Load
green Active
green
NE2: Hardware
failure
● ◆ ✕ ◆ ✕ ✕
NE3:Network test
failure
● ● ◆ ◆ ✕ ■
NE4:No IP address
or gateway
● ● ● ◆ ◆ ✕
NE5:Booted
wrong image
● ● ● ◆ ✕ ✕