Setting Run-time Parameters
893-743-A
4-27
Setting Run-time Parameters
When the boot sequence is complete and the image code is running, the Model
281xSA hub requires no further user intervention. However, if you want to
modify run-time parameters, type [Ctr]+Y to display the menu shown in
Figure 4-15. Using this menu, you can perform the following tasks:
■
Update IP and IPX configuration parameters or boot parameters
■
Set the Model 281xSA hub for out-of-band operation
■
Set SNMP parameters
■
Set the location string for the Model 281xSA hub
If you change any of these settings, you must store the new settings in NVRAM
(the w command) and either restart or reset the Model 281xSA hub (the r or z
command) in order for the new settings to take effect.
Figure 4-15. Menu for changing run-time parameters
SynOptics Model 2813SA Version 1.0.0 Main Menu
4766
MAC address:
Agent functionality:
00:00:81:xx:xx:xx
Advanced Analyzer
Enter command:
-i
-s
-o
-p
-b
-c
-w
-q
-r
-z
Set protocol parameters
Set SNMP parameters
Set out-of-band parameters
Set profile parameters
Set boot parameters
Set security parameters
Write values to EEPROM
Exit
Restart 2813SA
Reset 2813SA (takes 45 seconds)