Operator Manual for the Baxter ExactaMix 2400 Compounder
53007410 Rev. C
Page 23
INSTALLING THE COMPOUNDER
Your Baxter service provider will install the compounder at your site.
If you must reinstall the compounder or replace a component, verification tests must be
performed before you use the compounder again. Contact Baxter Technical Services for
assistance. Refer to Getting Help on Page 22.
To start, open the packaging, remove all the items and inspect them to make sure that they are
not damaged.
WARNING
Do not use sharp objects to open the packaging. Personal injury could result.
The compounder should be placed on a level and stable surface to prevent its
modules from moving out of position. Always hold the modules as shown below to
avoid dropping them.
1.
Route the power cord out through the routing hole in the back of the main module.
2.
Place the main module onto the base plate.
Placing the main module
3.
Place the load cell to the left of the base plate.
4.
Place the display to the right of the base plate.
5.
Tip the main module back and extend the support legs.
Extending the support legs
Support legs
Summary of Contents for ExactaMix 2400 Compounder
Page 2: ......