Programming the Pump
77
SIGMA Spectrum Infusion System
Pump Operating Software Version 8.00
Operator’s Manual
For Use With MDL Version 8.0
If soft limits are exceeded, press the
yes
soft key to accept the new value or the
no
soft key to
return to the previous value.
NOTE:
Values exceeding the hard limits set in the Drug Library will not be accepted by the
Pump.
5. Observe the change in the mL/hr rate based on the new dose entry.
6. Press
RUN
to begin delivery at the new dose rate.
To change rate mL/hr without stopping the Pump:
1. At the Infusion Running screen, press the
rate
change
soft key. See Figure 76.
2. Observe the displayed mL/hr soft limits. See Figure 77.
3. Enter a new mL/hr flow rate. See Figure 77.
4. Press
OK
to confirm new flow rate. See Figure 77.
If soft limits are exceeded, press the
yes
soft key to accept the new value or the
no
soft key to
return to the prior value.
Figure 76. Infusion Running Screen.
Figure 77. Rate Change Screen.