14. FASCIA INSTALLATION
Important: Before fitting the fascia complete section 13 as this will not be possible
with the fascia fitted.
1.
Remove any protective film from the fascia.
2.
Lay the fascia frame on a flat surface with
its front facing up.
3.
The fascia decorative trim is made up of four
sections. A bottom and top section of equal
length and two shorter sections of equal length
that are the side sections. These can be
identified as in figure 27.
4.
Remove any protective film from the trim
sections.
5.
Locate the side trims as in figure 28.
6.
Locate the bottom and top trims as in figure
29.
7.
(See figure 30) Supplied with the trim pack
are four cylindrical spacers and four screws to
secure them in place. The spacers also secure
the fascia trims in place. Place
the spacers over the holes in
the trim / fascia. Secure in
place with the screws supplied
(Do not use the mirror screws
as these are for the front of the
fascia. These have a
countersunk head that has a
threaded hole in the centre).
8.
Ensure that the fascia is
layed on a flat surface with its
front facing up. Carefully
unpack the fascia glass panel.
9.
Locate the glass panel onto the
spacers. Align the holes in the
glass with the spacers.
10.
Supplied with the trim pack
are four nylon grommets. Locate
a nylon grommet into each hole
in the glass panel.
11.
Supplied with the trim pack
Page 28
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 29 Fitting the bottom and top trims.
Figure 28 Fitting the side trims.
Figure 27. Identifying decorative
trims