16
CONTROL PANEL
Fig. 17 - Control panel and display
Display
EXT
MENU
MEM
1
2
3
6
5
4
Button
Power on
Power off
RESET
Water temperature
control knob
Display
Service toolgate
I N D U S T R I A L
D E S I G N
Innovita-Scaldabagno stagno-BAXI 7-04-2015
Proposta 1 - Pantone 431C
EXT
MENU
MEM
1. Presence of fault
2. Presence of flame (flame symbol)
Flame fault (symbol crossed out)
3. Hot water request in progress
4. Set point temperature
Faults / Alarms
5. Remote control connection (external model)
6. Solar system connection
USE OF THE APPLIANCE
Preliminary checks
Check that:
h
T
he data of the power supply networks corresponds to that
stated on the data plate
h
T
he data plate information corresponds to that of the power
supply networks (electric, water, gas)
h
T
he installation complies with the local regulations in force
h
T
he electrical connection to the mains and of the earthing
connection have been performed correctly.
Appliance start-up
Following the necessary checks, proceed with the following oper
-
ations:
Electrically power the water heater
Open the gas valve installed upstream of the water heater
Open the water tap at the bottom of the water heater
h
P
ress the power button
h
The display shows:
1. Software review
2. The type of gas for which the water heater was designed:
(G20) -
(G30) -
(G31)
3.
Low Emission product
4. Model:
(14Fi AM Blue) -
(17Fi AM Blue)
With the
first ignition
procedure completed, the display shows the
symbols
(Fig. 19).
Press the button to power the water heater, the display shows
the set point temperature, the symbol
(in case hot water re
-
quest in progress) and the symbol (in case of burner ON) (Fig. 18).
I N D U S T R I A L
D E S I G N
Innovita-Scaldabagno stagno-BAXI 7-04-2015
Proposta 1 - Pantone 431C
Fig. 18 - Display of appliance ON
