Remote Control
The remote control handset uses 2 x 1.5V AAA type batteries. For longer battery
life use only alkaline batteries. To install the batteries, slide the cover down on the
rear of the handset and remove. If the stove does not respond to the remote control
handset commands, it is likely that the batteries require replacement.
CLEANING AND MAINTAINING THE STOVE
Important Safety.
Before undertaking maintenance or replacing the light bulb(s) always disconnect
the stove from the electricity supply by removing the 3 pin plug and allowing the
stove to cool.
How do I Clean my stove?
The stove and plastic parts need only to be wiped clean with a dry soft cloth, do not use
polishes or abrasive materials.
I have a problem with my stove!
1. My stove functions manually but not by the remote control.
The batteries in the remote control handset probably need replacing. See top of this
page.
2. My stove is on but there is no light / low light.
Try adjusting the flame dimmer control (See figure 3). Alternatively this is possibly a
light bulb failure. Remove the light bulb as in the following section and check it in a
table lamp that is known to work. If it does not work in the table lamp then it needs
replacing as in the following sections.
The light bulbs fitted to this stove are 25Watt E14, 230Volt Edison fitting, candle style
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 5. Battery cover removal
