Baumuller BM5-SSL, Instruction Handbook Manual

Page: 43 / 80

Mounting and Installation
Instruction handbook Safe STO logic BM5-SSL
Document No. 5.18007.02
43
of 78
8
8.2.1 Prepare mounting
Based on the planning documents and the drilling patterns (see Z Dimensions – on page
23) the positions of the attachment drill holes can be determined.
NOTICE!
Property damage due to conductive contamination.
Therefore:
m When performing installation work of any kind, it must be ensured that no foreign
material (e.g. drill shavings, copper strands, etc.) gets into the device as a result.
m If possible, the drilling of the holes should be done before mounting the device and
the configuring of the cables should take place outside of the control cabinet. If this
is not possible, the device must be appropriately covered.

Remove this covering again prior to start!
CAUTION!
Eye injury due to flung particles.
Metal particles are flung when making the drill holes and the cutout sections.
Therefore:
Wear protective eye wear!
h Preparing drill holes.
NOTE!
Consider the minimum clearances for cooling (on top/on bottom100 mm) when mak-
ing the drill holes.
8.2.2 Mounting instruction
Mounting procedure:
1 Keep suitable fastening components readily available.
2 Mount the device