Description and checking of the operating- and displaying elements
Instruction handbook
CANopen slave
BM4-O-CAN-03
Document no. 5.02014.06
Baumüller Nürnberg GmbH
32
6.3
6.3
Description and checking of the operating- and displaying elements
The option module
CANopen slave
shows operating- and displaying elements. The op-
erating elements consist of 10 DIP switches in a common cabinet. The display elements
exist of 4 LEDs, which are integrated into the connectors on the front side.
DIP switch
For setting of the DIP switches refer to
LEDs
After turning on the b maXX 4400 the module is initialized, the LEDs are blinking in se-
quences.
NOTE
Should the plug-in module due to external conditions be pulled out of the device, turn off the
device. Then try to insert the plug-in module again, as we describe in chapter
6.4
Description/check of safety and monitoring elements
Before starting the commissioning of the option module
CANopen slave
it is necessary
to clear possible errors/error messages on the b maXX 4400 basic unit. This errors can
be caused by incorrect mounting (e.g. defect cables) or incorrect installation. The com-
missioning of the option module
CANopen slave
can be started after this errors are ac-
knowledged.
Summary of Contents for b maXX BM4-O-CAN-03
Page 69: ......
