Baumuller B MaXX 4000 Series, Instruction Handbook Manual

Page: 38 / 76

Requirements on the electrical connection
Instruction handbook b maXX (BM4-F-)DIO/FIO-XX (Digital IO module)
Document No. 5.01046.06 Baumüller Nürnberg GmbH
38
of 74
7.2
7.2 Requirements on the electrical connection
7.3 Requirements for the connection cables
Following cables are authorized for use by Baumüller:
m
Copper cable with cross-section of min. 0,75 mm
2
Figure 7: Remove insulation
NOTICE!
The danger is: Electricity.
In case you do not ensure the requirements to the electrical connection of the
Digital IO module , the DIO/FIO-XX or BM4-F-DIO/FIO-XX can be damaged/de-
stroyed.
m
Ensure that the electrical power connection parameters as specified in the techni-
cal data are adhered to and that the connections are made in accordance with the
instructions.
m
Avoid short circuit between input points and output points. In the event of a short
circuit between input points and output points the
DIO/FIO-XX or BM4-F-DIO/FIO-
XX may get destroyed.
NOTE!
Pay attention to EMC compatible cabling, see instruction handbook b maXX
BM4400, BM4400 ES, BM4600, BM4600 ES, BM4700, BM4700 ES (5.12008), chap-
ter
Installation requirements with regard to EMC .
Max. cross section Type of connection
1,5 mm
2
Connector, 10-pole