Baumuller B MaXX 4000 Series, Instruction Handbook Manual

Page: 35 / 76

Mounting
Instruction handbook b maXX (BM4-F-)DIO/FIO-XX (Digital IO module)
Document No. 5.01046.06
35
of 74
6
4 Turn the twist lock beyond and beneath by 90°.
The twist locks now are standing horizontally.
5 Take the front panel cover towards the front off. Keep this cover.
6 Take the BM4-F-DIO/FIO-XX out of its transport packing. Avoid the contact with elec-
tronically parts of the plug-in module.
7 Plug the BM4-F-DIO/FIO-XX module into the guide supports of the slot. The handle
must point to the same side as the other handles in this slot strip (here: right side).
8 Press with two fingers on the front panel until the BM4-F-DIO/FIO-XX module within
the device sensible latches tightly into the end position.
9 Turn the twist lock beyond and beneath by 90° into the vertical position (locking posi-
tion).
10 Connect BM4-F-DIO/FIO-XX with digital signals via connector.
11 Put the design cover on the device again.
Thus the mounting of the BM4-F-DIO/FIO-XX is completed.
NOTICE!
Note electrostatic discharge !
The BM4-F-DIO/FIO-XX contains ESD sensible parts.
Therefore:
m
Regard the described ESD procedures when handling the plug-in module.
m
Touch the plug-in module only at its handle.
NOTE
If you, within the scope of a repair of the BM4-F-DIO/FIO-XX , simply displace it by a
similar plug-in module, you can shorten the further operation, installation, commis-
sioning and so on. Then you simply must put on the connector to the plug-in module,
put on the design cover again and you can turn on the device again.