Baumuller b maXX 3000, Instruction Handbook Manual

Page: 13 / 220

Safety
Instruction handbook b maXX BM3000, BM3200, BM3300
Document no. 5.11018.11
13
of 218
2
2.4 Responsibility of the operating company
The device will be used in commercial areas. Thus, the proprietor of the device is subject
to the legal work safety regulations.
Along with the notes on work safety in this Instruction handbook, the safety, accident pre-
vention and environmental protection regulations valid for the area of application of this
device must be complied with. Whereby:
m The operating company must inform himself about the applicable work health and safe-
ty regulations and ascertain, in a hazard assessment, any additional hazards that could
arise from the special working conditions in the use area of the device. These must
then be implemented in the form of operating instruction for operation of the device.
m This Instruction handbook must be kept accessible to personnel working with the de-
vice at all times in the immediate vicinity of the device.
m The specifications of the Instruction handbook must be adhered to completely and
without exception.
m The device may only be operated in a technically faultless and operationally safe con-
dition.
2.5 Protective devices
IP code
Mains rectifier

BM300X
IP 00
Compact servo unit

BM320X, BM330X, BM321X, BM331X
IP 20
All devices BM3000, BM3200, BM3300 must be installed in an appropriate control cabi-
net to meet the IP code required in EN 61800-5-1, chapter 4.2.3.3 ( BM300X : IP00,
BM3200, BM3300 : IP 30: only upper horizontal surfaces; IP 20: all other surfaces).
DANGER!
Risk of fatal injury from electrical current!
The mains rectifier BM3000 protection code is IP00.

The operator is responsible for the protection against direct and indirect contact in the
switching cabinet.
There is an immediate risk of fatal injury if live electrical parts are contacted.
Therefore:
m The devices BM3200, BM3300 must be in operated inside of a control cabinet that
provides protection against direct contact of the devices and at least meets the re-
quirements of EN 61800-5-1, Chapter 4.2.3.3.