Baumr-AG HPS4500E User Manual Download Page 15

Page: 15 / 22

20 Ton Electric Log Splitter

E&OE

Log Splitter Operation

The machine must be operated by one person only. Do not allow helpers or bystanders

within 30m (90') of the machine. Bystanders should wear eye protection. • Make sure there

are no nails or foreign objects in logs to be split. • Log ends must be cut square. • Branches must be cut off

flush with the trunk. • Always split logs in the direction of the wood grain. • Do not load or unload logs whilst

the ram is moving. • Crush / amputation hazard - keep hands away from moving parts and from splits/cracks

that open in logs. • Do not remove jammed logs by hand. • Ensure that when initially retracting the ram that

the timber has split and is separated from the wedge.

If timber becomes jammed on the wedge and

moves up when retracting the ram, do NOT fully retract the ram as this may cause injury and/or

damage the machine. Remove the timber from the wedge before fully retracting the ram

. •

Do not

change the machine set-up between vertical and horizontal when the machine is running or timber is loaded

into the machine. • Ensure that the hydraulic ram assembly is locked into position before using the machine.

• Before use, check the hydraulic oil level with the ram in the fully retracted position. • Make sure all fittings

are secure before applying pressure. • Make sure the hydraulic hoses do not touch any hot surfaces or are in

or near the splitting area. • To avoid serious bodily injury, inspect the hydraulic system (hoses, fittings and

connections, and hydraulic pump) before operating the machine. Very high fluid pressure and temperatures

are created in the hydraulic system. Hydraulic fluid will escape through the smallest opening and can

puncture skin and cause severe injury and blood poisoning.

Never check for leaks with your hands or any

other body part while the hydraulic system is pressurised – use a piece of wood or other hard

material that any leak will be visible on. Seek medical attention immediately if injured by hydraulic

fluid

. • The hydraulic oil needs to be above -12°C (10°F) before starting the engine. Cold hydraulic oil can

damage the hydraulic pump. If the air temperature is below 0°C (32°F), allow the oil to warm up by extending

and returning the wedge several times before splitting wood.

Note that once the engine is running, the hydraulic pumping action of the machine activates. When the

engine is idling (slowest continuous running speed), the hydraulic pressure is minimal. As you increase

engine speed (use the engine throttle control), the hydraulic pressure increases. Note the following

recommendations:

•

Set-up and operate the machine on a dry and level surfaces with good footing. Do not work on mud,

loose, or slippery ground surfaces, and chock the wheels before use.

•

Lower the support leg (if equipped) from the towing arm position:

1. Unlock the support leg (

) from the towing position by removing the

locking pin (

2. Swing the leg down to the low position, then secure it with the locking pin.

•

Connect the machine to a 240VAC mains electrical supply.

•

Press the "ON" ("I") button to switch on the motor. To

switch off the motor, press the "OFF" ("O") button.

•

Maintain a clearance of at least 2.5m (7') around the

machine at all times to any combustible material.

BAUMR-AG BAUMR-AG BAUMR-AG BAU