CHANGING THE
LIGHT
BULBS
Note: All parts removed
during this process
must be sav
ed and refitted
after the bulb has been replaced.
Before removing the LED light,
unplug
the wine cooler
from your mains supply.
Failure to do so could result in electrical
shock or personal injury.
You should use
an
LED
bulb
which is
of the same type as the bulb
originally supplied with the appliance.
Make
sure
that
the wine cooler
remains
in the upright position during
transportation.
Tape the doors shut.
Turn the levelling
feet fully
up to the base to avoid damage.
Securely tape down all loose items inside
of
your wine cooler.
Remove all
of
the bottles.
Moving Your Wine Cooler
During long absences, remove all
of
the bottles; unplug your wine cooler,
clean
it
, and leave the door open slightly to avoid
the
possible
formation
of condensation
or
mo
uld.
Vacation Time
Most power failures are corrected within a few hours and should not
affect the temperature of your wine cooler
, as long as
you minimize the
number
of times
that
the door is opened. If the power is going to be off
for a longer
period of time, you
should
take steps to protect
the contents
of your wine cooler.
Power Failure
Maintenance of Your Wine Cooler
Unplug the wine cooler, and remove
all
bottles.
Wash the inside with a
mixture of
warm water and baking soda.
The solution should be
approximately
2 tablespoons of baking soda to
one
quart of water.
Wooden shelves do not require cleaning.
The outside of the wine cooler should be cleaned with
a
mild detergent
and warm water.
It may also be necessary to periodically wipe the bottom part of the
storage area, as the wine cooler is designed to retain humidity, and
condensation may collect there.
Cleaning Your Wine Cooler
CARE AND MAINTENANCE
11
12
The
light bulbs have been switched off with the
The LED light has burn
t
out(see maintenance section
for the replacement procedure).
The wine cooler is unplugged.
The home circuit breaker or fuse has
tripped.
The wine cooler does not have the correct
ventilation
The door gasket does not seal properly.
The temperature control is not set correctly.
The door is not closed completely.
The door
has been
opened too often.
A large amount of warm wine has been added to the
wine cooler.
The room temperature is hotter than normal.
The wine cooler does not have the correct
ventilation
The door gasket does not seal properly.
The door is not closed completely.
The door
has been
opened too often.
The e
xternal environment may require a
lower
setting.
Wine cooler is
not cold enough.
The circuit breaker
has
tripped or
a fuse has
Wine cooler does
not operate.
PROBLEM
TROUBLESHOOTING GUIDE
You can solve many common wine
cooler
problems easily, saving
you
rself
the cost of a possible service call. Try the
hints
below
to
see if you can solve the problem before calling
the Baumatic Service
Troubleshooting
POSSIBLE CAUSE
Not plugged in.
T
he temperature
control is not set correctly
.
Compressor turns
on and off frequently
The light does
not work.
Troubleshooting
Department.
blown.
clearances to the rear or side of the wine cooler.
clearances to the rear or side of the wine cooler.
light bulb ON/OFF switch.
