Baumatic BWE40, Instruction Manual

Page: 20 / 30

Your Baumatic BWE40 Wine Cooler
19
- The Shelves are out
of position
- Check that all shelves
are correctly placed so
that nothing can push
out the door from within
your Wine Cooler.
- Too high a setting - Lower setting.
Too Cold!
- Ambient
Temperature is too
low
- Turn heating on in
room or move your Wine
Cooler to a warmer
place.
Reversing your Wine Cooler’s Door Swing
Your Wine Cooler’s door can open either from the left or the right side. It is
delivered to you with the door opening from the left side. Should you want to
reverse the opening direction, please follow these instructions:
* Note : Before Reversing door, the power must be shut off.
All parts removed must be saved close to hand for reinstallation
of the door.
To change the hinges from the right hand side:
1) Remove the upper hinge cover (6).
2) Remove the two screws (1) that
hold the upper hinge (5) (right side)
to the frame. Take away the upper
hinge (5).
3) Lift the door and put it on a padded
surface to keep it safe from
scratches or shocks.
4) Remove the two screws (8) that
hold the lower hinge (2). Make sure
you remove the lower hinge (2).
5) Remove the left front leg (4) and
transfer it to the right side.
6) Move the hole cover plate (7) to the
right side.
7) Before placing the lower hinge (2),
remove the bolt-pin (9) and reverse
the direction of the lower hinge (2).
Then install the lower hinge (2)
onto the left side of the lower
frame with two screws (8).
8) Insert the bolt-pin (9) to the
lower hinge (2).
9) Set the door to its place
making sure the door seats
into the lower hinge (2).
10) While holding the door in the
closed position, secure the
upper hinge (5) in the top
frame of the left side with two
screws (1), being careful not
to tighten them until the top
of the door is levelled with
your Wine Cooler’s counter
top.
11) Install the upper hinge cover
(6) on the upper hinge.