18
o
Unscrew the two screws (8) that hold the bottom right hand
hinge (5) to the frame. Take away the bottom hinge (5).
o
Lift the door off the right upper hinge (2) and place it on a
cushioned surface to prevent scratching it.
o
Unscrew the two screws (4) holding the front top panel (1) in
position. Pull gently to remove the front top panel.
o
Unscrew the screw nut of the right upper hinge bin (3). Refit the
upper right hinge bin (3) into the left upper hinge (10).
o
Unscrew the left front leg (9) and transfer it to the right side.
o
Set the door in place, making sure the door is seated at the left
upper hinge bin (10).
o
Before replacing the bottom hinge (5), remove the bolt-pin (6)
and reverse the direction of the bottom hinge (5).
o
Insert the bolt-pin (6) into the bottom hinge (5).
o
While holding the door in the closed position, attach the bottom
hinge (5) onto the left side of the bottom frame with two screws
(8). Do not tighten the two screws (8) until the top of the door
is parallel to the counter top.
Positioning
o
It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
+10 to +32 degrees centigrade
N
+16 to +32 degrees centigrade
ST
+18 to +38 degrees centigrade
T
+18 to +43 degrees centigrade
o
Positioning the appliance requires two people in order to avoid
injuries or damage to the appliance.
o
Keep a minimum of 50 mm between your freezer and the back
wall. There should also be a gap of 25 mm either side and 50
mm clear space above the freezer. If there is insufficient space
this can create the sound of vibration, weakening of the
appliance’s power and a waste of electricity.
