Baumatic BMEH64EF, Instructions For Use And Installation, Page: 9 / 24

9
Turning coking zone off • Selected hotplate must be activated.
• Touching the hotplate sensor (E) set the power level to »0«. After 10 seconds the
hotplate is turned off.
Fast deactivation
• Selected hotplate must be activated.
• Press both (C) and (E) sensors simultaneously, and the hotplate is immediately
switched off.
Turning the hob off The hob can be switched off any time by pressing the sensor (A).
Child lock
By activating the child lock protection you can stop the operation of the appliance, the
use of hotplates, protecting the children from accidental start and eventual injury.
Activating child lock
• Switch all hotplates off (setting “0”).
• Touch sensor (A) and activate the hob (in case it was idle). All displays indicate »0«.
• Press sensors (D=C+E) simultaneously. After the beep press the sensor (C) again. All
displays indicate letter »L«, which disappears after 20 seconds. Child lock is now
activated.
Turning child lock off
• Protection is switched off by pressing the sensor (A). All displays indicate the letter L..
• Press simultaneously sensors (D=C+E). After the beep press sensor (E) again. Child
lock is now off.
Remaining heat indicator
Glass ceramic hob also features remaining heat indicator “H”. As long as the symbol “H”
is on after the hotplate was switched off, the remaining heat may be used for warming up
food or for melting.
Even when the symbol “H” disappears, the hotplate may still be hot.
Be careful of burns!
Operation time limit For improved safety, your cooking hob is fitted with a device that limits the duration of
the cooking hob operation for each cooking zone respectively. The duration of operation
is measured from the last change made to the power level settings for a particular
cooking zone. If the power level is not changed for a while, the cooking zone will
automatically be switched off after a certain period of time which depends on the power
level (see table below).
Level 1 2 3 4 5 6 7 8 9
Limit Time (h) 6 6 5 5 4 1,5 1,5 1,5 1,5
SAFETY FUNCTIONS AND ERROR DISPLAY
ERROR
CODE
ERROR DESCRIPTION INSTRUCTION MANUAL
ER03 &
permanent
tone Permanent use of keys; Control unit cuts off after 10 sec;
Water or cooking utensils on the glass above the control
unit. Cleaning of the operational surface. If the
problem persists, contact authorized center
for technical assistance - specifying the error
code.
ER21 Control unit cuts off due to overheating to avoid damage
to electronics.
Ambient temperature of electronics still too high. Allow cavity to cool down. If the problem
persist, contact authorized center for
technical assistance - specifying the error
code.
U400 Secondary voltage of the power unit to high (primary >
300V). Control unit cuts off after 1 sec releasing a
permanent tone.Control unit is wrongly connected. 1)Contact an electrician to check the home
supply mains.
2)Contact authorized center for technical
assistance - specifying the error code.
ER22 Key evaluation defective. Control unit cuts off after 3.5 –
7.5 sec.Short-circuit or discontinuation in the range of
the key evaluation. Contact authorized center for technical
assistance - specifying the error code.
ER36 NTC value is not within its specification; control unit cuts
off.Short-circuit or cut-off at NTC.
Contact authorized center for technical
assistance - specifying the error code.