18
e hob into position (see
drawing opposite).
spillages from penetrating the underneath of the hob.
aperture in future, particularly if it needs to be
serviced.
Carefully lower it into the aperture hole that you have cut out.
C) Sealing strip
hed to the hob, but so that you can still adjust
the position of it.
hen fully tighten the screws
(B) to secure the hob into position.
o
IMPORTANT: There are ventilation holes around
the outside of the hob. YOU MUST ensure that
these holes are not blocked by the work top,
when you put th
o
NOTE: Your appliance comes fitted with a sealing
strip already attached to the underside of the hob.
This should not be removed as it will prevent liquid or
o
IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the
o
(A) Clamp
(B) Screw
(
o
Place the clamp (A) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw (B) through the clamp (A) so that
the clamp is attac
o
On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. T
Summary of Contents for BHC609
Page 1: ...avecf BHC609 60 cm Front touch control ceramic hob ...
Page 26: ...26 ...
Page 27: ...27 ...
Page 28: ...28 ...
