BAUMATIC
BFD62W dishwasher user manual
14
FORGET TO ADD A DISH?
A FORGOTTEN DISH CAN BE ADDED AT ANY TIME BEFORE THE DETERGENT
DISPENSER OPENS.
•
OPEN THE DOOR A LITTLE TO STOP THE WASHING.
•
WAIT ABOUT TEN SECONDS. AFTER THE SPRAY ARMS STOP WORKING,
YOU CAN OPEN THE DOOR COMPLETELY.
•
ADD FORGOTTEN DISHES.
•
CLOSE THE DOOR, THEN THE DISHWASHER WILL WORK.
14
NEED TO INTERRUPT A CYCLE?
If an emergency arises, you can stop the machine at any time by pressing the
ON/OFF button. Remember to wait approx. 10 seconds before you open the door
fully, as the spray arms continue to turn after the power has been cut and could spray
hot water up at you. DO NOT TURN THE KNOB AHEAD AS THIS WILL AFFECT
THE WASHING RESULT! YOU ALSO COULD JUST PULL THE DOOR OPEN – DO
NOT TOUCH ANY BUTTONS!
NOTE:
If you need to change a cycle, you can as long as the dishwasher has only been
running for a short time. Just press the ON/OFF button so the ON light goes out, turn
the knob to the setting you want then turn the dishwasher back on with the ON/OFF
button.
However, if it’s been a long time since the old cycle began, the detergent may have
already been released and the wash water drained out. You’ll need to start a new
cycle altogether so press the ‘ON/OFF’ button to switch the dishwasher off, wait until
the inside cools before you refill the detergent dispenser, close the door and then turn
the knob to the cycle setting you want before you turn your dishwasher back on.
TAKE CARE WHEN OPENING THE DOOR DURING
WASHING. THE HOT WATER MAY SCALD YOU!
AT THE END OF THE WASH CYCLE
When the knob stops turning and lines up with the STOP mark (see
figure), the cycle has finished. Turn the dishwasher off using the ON/OFF button
and open the door of the dishwasher. Wait a few minutes before unloading the
dishwasher so the dishes can cool down. This will make them less breakable and
allow them to dry better.
