Baumatic BDWI660-AUS, Instruction Manual, Page: 26 / 48

26
o
After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
Changing the wash program
IMPORTANT: This should only be attempted when the cycle has
only just started, otherwise the detergent may have already
been released or you could have hot water escaping.
o
Slightly open the door of the appliance and press the program
button for about 3 seconds.
o
The machine will cancel the program in progress and you can
then select the required program as usual.
Adding more dishes
IMPORTANT: This should only be attempted when the cycle has
only just started, otherwise the detergent may have already
been released or you could have hot water escaping.
o
Open the door a little way to pause the current program. Wait
until the spray arms have stopped rotating before opening the
door fully.
o
The program light will stop blinking and a buzzer will sound
every minute until the door is closed again.
o
Add the forgotten dishes to the upper or lower basket.
o
Close the dishwasher door. After about 10 seconds the wash
program will continue automatically.
At the end of a wash program
o
The time display will flash for 8 seconds and a buzzer will sound.
o
Open the door of the appliance.
o
Use the ON/OFF button (5) to switch the dishwasher off.
o
Wait for about 15 minutes before unloading the dishwasher to
avoid handling the dishes and utensils while they are still hot and
more susceptible to breakage. They will also dry better.
o
It is recommended that you unload the lower basket first to
avoid water dripping from the upper basket onto the dishes in
the lower one.